- Help Center
- 06. Web App Reports
- Energy Monitoring Reports
-
01. Getting Started with Lumos Controls
-
02. Commission & Configure the Devices
- Settings before Device Commissioning (Pre-Commissioning)
- Control Devices- Commission
- Control Devices- Configure Output Channel Settings
- Control Devices- Configure Light Configuration Settings
- Control Devices- Configure Device Power Settings
- Control Devices- Configure Device Configuration Settings
- Control Devices- Configure Input Sensor Settings
- Sensors- Commission & Configure
- Switches- Commission & Configure
- Gateway- Commission & Configure
- Repeater- Commission & Configure
- Beacon Settings
- FAQ
-
03. Mobile App Features
-
04. Automate Lighting Experience
- Scene Schedule
- Motion Based Automation- Using Wireless Sensor
- Motion Based Automation- Using Wired Sensor
- Daylight Harvesting
- Daylight Harvesting using Open Loop mode
- Daylight Harvesting using Closed Loop mode
- Daylight Harvesting using Custom mode
- Automated Demand Response
- Human Centric Lighting
- FAQ
-
05. Web App Features
-
06. Web App Reports
-
Emergency Lighting
-
BMS Integration
-
Troubleshooting Guide
-
FAQ
-
Technical Data Sheets & Installation Guides
- Controller- Radiar D10
- Controller- ARD32
- Controller- ARD4
- Controller- AFD1/4
- Controller- AF10
- Controller- AR10
- Controller- Omni TED
- Driver- Ldrive 32W
- Driver- Ldrive 36W
- Driver- Ldrive 42W
- Driver- Ldrive 60W
- Sensor- Cyrus C
- Sensor- Cyrus F
- Sensor- Cyrus AP
- Sensor- Cyrus AM
- Switch- Catron IV
- Switch- Catron V
- Switch- Catron AI
- Gateway- Enor U
- Gateway- Enor E
- Repeater- Senor E
- Others- WIM2480
- Others- LED Flat Panels
- Others- Retrofit Troffers
- Warranty Docs
-
Release Notes
-
Other Articles
Pre-requisites for Energy Consumption reports data to be accurately recorded
Radiar AR10, Radiar AF10, Radiar AFD1
To ensure that accurate data is available in Energy Consumption Reports, the below are required-
- A controller (Either Radiar AR10, Radiar AF10, or Radiar AFD1) needs to be connected to the luminaire for which energy consumption data needs to be recorded.
- There has to be a gateway (Enor E, Enor U) in the ecosystem, with an active connection to the cloud via the internet.
- The Power Rating of the luminaire associated with the controller needs to be set correctly in Controller Settings. Please refer here to learn how to set the power rating of a controller - https://knowledgebase.lumoscontrols.com/knowledge/how-to-configure-the-power-rating-of-a-device-using-mobile-app
You can also visit the following sections for more information:
To know about the Devices needed to perform smart Emergency testing using the Lumos Controls system, click here
To know how does the Lumos Controls BMS integration work, click here