-
01. Getting Started with Lumos Controls
-
02. Commission & Configure the Devices
- Settings before Device Commissioning (Pre-Commissioning)
- Control Devices- Commission
- Control Devices- Configure Output Channel Settings
- Control Devices- Configure Light Configuration Settings
- Control Devices- Configure Device Power Settings
- Control Devices- Configure Device Configuration Settings
- Control Devices- Configure Input Sensor Settings
- Sensors- Commission & Configure
- Switches- Commission & Configure
- Gateway- Commission & Configure
- Repeater- Commission & Configure
- Beacon Settings
- FAQ
-
03. Mobile App Features
-
04. Automate Lighting Experience
- Scene Schedule
- Motion Based Automation- Using Wireless Sensor
- Motion Based Automation- Using Wired Sensor
- Daylight Harvesting
- Daylight Harvesting using Open Loop mode
- Daylight Harvesting using Closed Loop mode
- Daylight Harvesting using Custom mode
- Automated Demand Response
- Human Centric Lighting
- FAQ
-
05. Web App Features
-
06. Web App Reports
-
Emergency Lighting
-
BMS Integration
-
Troubleshooting Guide
-
FAQ
-
Technical Data Sheets & Installation Guides
- Controller- Radiar D10
- Controller- ARD32
- Controller- ARD4
- Controller- AFD1/4
- Controller- AF10
- Controller- AR10
- Controller- Omni TED
- Driver- Ldrive 32W
- Driver- Ldrive 36W
- Driver- Ldrive 42W
- Driver- Ldrive 60W
- Sensor- Cyrus C
- Sensor- Cyrus F
- Sensor- Cyrus AP
- Sensor- Cyrus AM
- Switch- Catron IV
- Switch- Catron V
- Switch- Catron AI
- Gateway- Enor U
- Gateway- Enor E
- Repeater- Senor E
- Others- WIM2480
- Others- LED Flat Panels
- Others- Retrofit Troffers
- Warranty Docs
-
Release Notes
-
Other Articles
Configure Low-End Trim
Low-End Trim defines the lowest light intensity, other than zero, that a device shall give out. When low-end trim is configured at 1%, you can ensure that your lights don't turn Off when they are dimmed to their lowest setting.- Go to the 'Devices' tab
- Click on the
icon of the light device (In case of DALI, click on the icon corresponding to the connected DALI driver)
- Select 'Light Configuration Settings'
- In the option 'Low-End Trim', enter the required value
- The default value will be 1%
You can also visit the next sections:
To create Groups, click here
To know about Space, click here
To create a Scene, click here
To know about Animation, click here