How to commission Sensors using the Lumos Controls mobile app?

Applicable for Radiar SD10, Cyrus AP, Cyrus AM, Cyrus C, Cyrus F

1. Power the sensor ON, and it will be in pairing mode, ready to be commissioned. Sensor shall be in commissioning mode for 3 minutes. During this period, the device LED shall blink every second (500ms ON and 500ms OFF)
2. From the top right corner of the app, choose the zone into which you want to commission the sensor 
3. Go to the 'Devices' tab
4.  Click on the '+' button and choose the 'Add Device' option
5. Click on 'Tap here' and the sensor will be listed
   
6. To identify the device, click on the 'Locate' button. The device LED shall blink every 3 seconds (1.5sec ON and 1.5sec OFF)
7. Press the '+' button corresponding to the sensor and the sensor will be commissioned
   

You can also visit the following sections for more information:
To know how to Commission & Configure Control Devices, click here
To know how to Commission & Configure Switches, click here
To know how to Commission & Configure Gateway, click here
To know how to configure Device Settings, click here
To know the Operations and Control details, click here
To know regarding Group settings, click here
To configure Motion Based Automation, click here
To configure Daylight Harvesting, click here
To configure Light Schedules, click here